CD TEST MODE
QQ
3 7 63 1515 0
1. Starting CD Test Mode
Insert the AC plug while pressing and holding down the CD OPEN/CLOSE button.
When the test mode is activated, the display appears TEST.
2. Exiting CD Test Mode
Press the POWER button or unplug the AC plug.
3. CD Test Mode Buttons and Functions
No
Mode
Buttons
1
Start Mode
2
Search Mode
STOP button
3
Play Mode
PLAY button
4
Traverse Mode PAUSE button NORMAL
5
Sled Mode
FF button
TE
L 13942296513
FWD button
6
Spindle Mode
REC/REC
MUTE button
*1
When the focus search mode is repeated more than 10 minutes, the driver IC may generate heat, activating the protection
circuit to stop operation. In this case, turn off the power, leave the unit for a while, and then, restart.
*2
When the pickup is positioned at the innermost track or the outermost track, and the FF button and the RWD button are
pressed down, the sled motor rotates. Therefore, observe gear to avoid damage.
www
.
http://www.xiaoyu163.com
Display
All lit.
All FL lit.
READING
LD continuously lit.
Continuous focus search *1
Spindle motor continuous kick
NORMAL
Normal playback
Focus search continued if
Tracking servo OFF/ON
CD TEST
PU moves the inner track *2, and
CD TEST
PU moves to the outer track *2,
All lit.
When the button is pressed at
x
ao
u163
y
i
http://www.xiaoyu163.com
2 9
8
Operation
TOC READ is unavailable.
OFF/ON repeated every time the
PAUSE button is pressed.
Q Q
lens is kicked to the inner track.
3
6 7
1 3
1 5
and lens is kicked to the outer
track.
first, spindle motor rotates in the
FWD direction (at rough speed).
At the second press, the direction
is reversed. At the third press, the
mode stops.
co
.
32
9 4
2 8
Details
FL check
Microcomputer check
APC circuit check
Laser current electricity
measurement
Focus search waveform check
Focus error waveform check
(DRF is ignored during search
mode.)
Servo circuits check
DRF check
Tracking balance check
Sled circuit check
Tracking circuit check
0 5
8
2 9
9 4
2 8
Mechanism function check
PU check
Spindle circuit check
Spindle motor check
m
9 9
9 9