2.4ghz 802.11g wireless-g access point with power over ethernet (21 pages)
Summary of Contents for Linksys WRT610N V1
Page 1
Thank you for purchasing the 6dBi Antenna Mod Kit for your Linksys router. First we will show you how to install the antennas for your router. Next we will provide you with a tool that will help test the performance of your newly modified router.
Page 2
4. Now this part requires some patience. 5. Fitting your new UFL connectors into the little holes can take a little practice, and patience 6. So do this first: Practice removing the original UFL antenna cables and then putting them back on. 7.
Page 3
8. Now you are ready to drill. 9. Detach the stock UFL cables and remove the board from the unit. 10. Mark on the unit with a pen or whatever where you want to drill.
Page 4
11. Your mark should be just a fraction above center point so the RP-SMA adapter will clear the board. <<Very important IF YOU DRILL TOO LOW THE BOARD WON’T CLEAR 12. Drill a smaller hole first with a smaller bit and then go ahead and finish the drilling with the 1/4" drill bit.
Page 5
WIFI Radar Scanner: http://www.metageek.net/products/inssider/ (free download) The WIFI Radar Scanner will show the signal strength of your router. We recommend using it before and after installing the antennas to see the improvement of the signal strength. It can also show you which antenna position and router location can give you the best signal.