Panasonic AJ-D750P Operating Instructions Manual page 18

Controls and their functions (continued)
<Connector area>
ANALOG COMPONENT VIDEO OUT connector
The analog component video signal is output from this connector.
ANALOG COMPOSITE VIDEO OUT connectors
The analog composite video signals are output from these connectors.
The video signal with signals superimposed on it can be output from the VIDEO OUT3
connector.
The superimpose function can be set ON or OFF on the setup menu No. 006 (SUPER).
DIGITAL AUDIO IN/OUT connector
SERIAL DIGITAL COMPONENT AUDIO/VIDEO IN/OUT connector
(optional AJ-YA750P interface board required)
This I/O connector is for digital component audio and video signals which comply with the
SMPTE 259M-C/272M standard.
Remote control connectors
The unit can be controlled from an external source by connecting the unit with another
unit or an external controller.
There are two remote control connectors, one for IN/OUT uses and the other for OUT
uses.
IN/OUT: For connection with an external controller.
OUT:
ENCODER REMOTE connector
The external encoder/controller is hooked up to this connector when the video output
signal and other settings are to be adjusted from an external source.
RS-232C connector
PARALLEL REMOTE connector
This is used when operating the unit from an external source.
This I/O connector is for digital audio signals which comply with the AES/EBU standard.
For connection with deck-to-deck operation.
For connection with parallel running operations.
For use in a loop-through configuration.
- 1 8 -