Table of Contents
Advertisement
USER menu
<VIDEO>
No.
600
601
602
603
604
605
606
608
611
The underline on the setting item denotes the initial setting.
Item
Setting
Superimposed
Superimposed
No.
display
display
P
/P
0000
B
R
IN LV
0001
INT SG
0000
0001
0002
INPUT
0000
C KILL
0001
OUT
0000
VSYNC
0001
V-MUTE
0000
N-MUTE
LOW _ RF
SEL
0001
CC (F1)
0000
BLANK
0001
CC (F2)
0000
BLANK
0001
FREEZE
0000
SEL
0001
EDH
0000
0001
M
II
This selects the component input signal level.
0: M
II
level.
B-CAM
1: ß cam level.
OFF
For selecting whether an internal signal is to be generated.
0: No signal is generated.
BB
1: A black burst signal is generated.
CB
2: A 100% color bar signal is generated.
<Notes>
• The INT SG message appears for 2 seconds when recording
commences.
• If the VIDEO INPUT switch #3 is set to DVCPRO/DV, the
audio signals will also serve automatically as the internal
signals when a video signal has been selected as the
internal signal by this menu item setting.
B/W
This selects color killer processing for the video input signals.
0: The signals are forcibly processed as B/W signals.
AUTO
1: The signals are automatically processed.
N-VF
This selects whether to float the vertical sync position of the
video output in order to align the video output phase with the
VF
input in the EE/record/edit modes.
0: Signals are not floated.
1: Signals are floated.
This selects whether the video output signal is to be muted
when the blank portion of the tape is detected during playback.
0: No muting
1: Muting (picture turns grey).
BLANK
This selects ON or OFF for the closed caption signal in the
first field.
THRU
0: Forced blanking performed.
1: Blanking not performed.
BLANK
This selects ON or OFF for the closed caption signal in the
THRU
second field.
0: Forced blanking performed.
1: Blanking not performed.
FIELD
For selecting how the still picture is to be output.
0: Field output
FRAME
1: Frame output
<Note>
When frame output is selected, the frame slow mode will be
established during slow motion as well.
OFF
This selects whether to superimpose EDH onto the serial
output signals.
ON
0: EDH is not superimposed.
1: EDH is superimposed.
<Notes>
• This display will not appear unless the AJ-YA455P serial
interface board (optional accessory) has been installed.
• Even when 1 (ON) has been selected, EDH is not super-
imposed at the SERIAL OUT 3 connector if the SUPER ON/
OFF switch is at the ON position.
33
Description
Advertisement
Table of Contents
