Panasonic MC-UG693 Operating Manual (English, Spanish) Operating Instructions Manual page 54

Agitator
Agitateur
Agitador
Nozzle Base
Partie inférieure
de la base
Base
Agitator
Agitateur
Agitador
Latches
Languettes
Pestillos
Tabs/Slots
Languettes/fentes
Lengüetas/ Ranuras
Agitator Cover
Couvercle de l'agitateur
Cubierta del agitador
Slot
Fente
End Cap
Ranura
Bouchon
Tapo del
extremo
Belt
Courroie
Correa
Furniture
Guard
Retainer
Retenue de
pare-chocs
Sujetador del
protector
de meubles
Post
Borne
Pestaña
Note: See PARTS IDENTIFICATION for
belt number.
➢ ➢ Loop the other end of the belt on
the belt pulley on the agitator.
➢ ➢ Insert the agitator by placing the
rounded portion of the end cap
down into the slot in the nozzle
base.
Note: It may be necessary to hold the
furniture guard out of the way in order
to allow proper insertion of the agitator
into the nozzle base.
Note: Care must be taken due to the
belt tension during reassembly.
➢ ➢ Press firmly, checking to see that
each end is completely inserted.
➢ ➢ Check to see that the belt is
centered on the belt pulley. Turn the
agitator with your fingers to see that
it turns freely.
➢ ➢ To re-attach the agitator cover,
insert the six (6) tabs into the six
slots along the front edge of the
nozzle base.
➢ ➢ Lower the agitator cover to its
original position.
➢ ➢ After positioning the agitator cover,
push forward on the two (2) locking
tabs in order to ensure that they are
securely in place.
➢ ➢ Re-fasten the furniture guard
retainers to the posts on both sides
of the agitator cover.
- 54 -