Manual Clock Set; Reset All Unit Memory Functions - Quasar Omnivision VV-1303 Owner's Manual

Manual Clock Set

If AUTO CLOCK SET was incomplete, manually
set the clock as follows.
Press ACTION
1
SET CLOCK Menu screen.
Press to select the month and
2
press to set. In the same manner,
select and set the date, year, time, and
DST. (Daylight Saving Time)
Press ACTION twice to start CLOCK and
3
exit.
POWER
ACTION
on the remote to display
SET CLOCK
:
1 / /
DST : ON
SELECT : SET :
END : ACT I ON
SET CLOCK
:
2 / 6 / 2003 THU 12 00PM
DST : ON
SET COMPLETED
SET :
START : ACT I ON
SELECT/SET
:CH UP
:CH DOWN
:VOL UP
:VOL DOWN

Reset all unit Memory Functions

When moving unit to a new location, or if a mistake
was made in the Initial Setup section.
• Make sure a tape is not inserted in the unit.
POWER
VIDEO IN VIDEO IN AUDIO IN AUDIO IN
1
Turn the unit
Power on.
Press and hold both
2
PLAY/REPEAT and FF on the
unit for more than 5 sec onds.
• The power will shut off.
• Please ignore "NO CASSETTE"
warning.
3
Do "Initial Setup" on page 8.
Note to CABLE System Installer
This reminder is provided to call the CABLE
(Cable TV) System Installers attention to
Article 820-40 of the NEC that provides
guidelines for proper grounding and, in
par tic u lar, specifi es that the cable ground
shall be con nect ed to the grounding system
of the building, as close to the point of cable
entry as practical.
VOL CH STOP/EJECT REW/ STOP/EJECT REW/ PLAY/REPEAT FF/ PLAY/REPEAT FF/ REC REC TIMER TIMER
REC ON TIMER REC ON TIMER PROG TIMER PROG TIMER
9 9