EWB100 Usage and Deployment Guide
Rev 1.13
17 MSP Support
The EWB100 supports MSP for configuration and firmware updates. Information
MSP and how to use it to support the EWB100 is found in the MSP User
Documentation. This section describes configuration commands for MSP
There are two MSP configuration commands and they only allow MSP to be
disabled. MSP can only be enabled via the MSP staging process.
17.1.1 MSP Mode
This command disables the MSP client. The format is:
Set msp mode disable
The default is enabled.
17.1.2 MSP Default Mode
This command disables user default mode of the MSP client. The format is:
Set msp def_mode disable
The default is disabled.
Page 89