Surface Units - GE MNU720 Use And Care Manual

Surface Units

Spatters and spills burn away when coils are heated.
At the end of the meal, heat soiled surface units at HI.
Let soil burn off for about one minute, then switch
surface units to OFF,
Avoid getting any cleaning materials on the coils. If
you do, wipe off with a damp paper towel before
heating the surface unit.
Clean the area under the drip panhings often. Built-
up soil, especially grease, may catch fire. To make
cleaning easier, plug-in units are removable.
Plug-In Units
Plug-in units can be removed.
Lift a plug-in unit about 1 inch
above the trim ring—just enough
to grasp it—and you can pull
it out.
12
CARE AND
(continued)
Do
not lift a plug-in unit more
than 1 inch. If you do, it may not
lie flat on the trim ring when you
plug it back in.
Repeated lifting of the plug-in
unit more than 1 inch above the
trim ring can permanently
damage the receptacle.
Receptacle
CLEANING
Caution: Be sure all controls are turned to OFF and
surface units are cool before attempting to lift or
remove them.
After removing a plug-in unit, remove the drip
pan/rings. Wipe ~ound the edges Qf the surfa~e unit
opening. Clean the area below the unit. Rinse all
washed areas with a damp cloth or sponge.
To replace a plug-in unit:
the surface unit cavity found on
top of the cooktop so the unit
receptacle can be seen through
the opening in the pan.
Insert the. terminals of the plug-in
unit through the opening in the
drip pan and into the receptacle. '-
Guide the surface unit into place
so it fits evenly into the trim ring.
CAUTION
Do not attempt to clean
plug-in surface units in an
automatic dishwasher.
Do not immerse plug-in surface
units in liquids of any kind.
Do not bend the plug-in surface
unit plug terminals.
Do not attempt to clean,
adjust or in any way repair
the plug-in receptacle.