Clock; Child Lock; Reset Receiver; About (Software Version) - Sharp LC-32WD1E Operation Manual

DTV menu operations

Clock

The Clock menu allows you to specify the clock settings.
1
Repeat steps 1 - 2 in "Installation" on page 24.
2
Press
3
Press
the setting. If needed, press
settings.
Automatic
Manual
Time Zone
Daylight
Savings

Child Lock

The Child Lock setting blocks children from accessing
unwanted channels or content and some on-screen display
menus.
You can block access by specifying the specific channel to
block or you can specify a maturity rating.
If you try to access blocked content when Child Lock is set
to "On", the PIN input menu displays. Entering the correct
PIN lifts the child lock temporarily until the TV enters
standby mode. Enter the PIN using 0–9.
1
Press DTV MENU.
2
Press
• The DTV Installation menu displays.
3
Press
4
Press
to turn the setting "On" or "Off".
5
Press
digit PIN using 0–9.
6
Press
enter the PIN.
Downloaded from www.Manualslib.com
/ to select Clock, and then press OK.
/ to select Time Zone, and
/ to select other
The TV will automatically set the
time using the information from
the input source.
Allows manual setting of the TV
clock.
Select the number of hours
before or after Greenwhich Mean
Time (GMT).
Set to observe or not observe
daylight savings.
• Yes — The clock will
observe daylight savings
time.
• No — The clock will not
observe daylight savings
time.
• Automatic — The TV will
automatically adjust to
observing or not observing
daylight savings time at the
appropriate points in the
year.
/ to select Installation, and then press OK.
/ to select Child Lock, and then press OK.
/ to select Child Lock, and then press
/ to select PIN Code, and then enter a 4-
/ to select PIN Code Again, and then re-
manuals search engine
7
Press
/ / /
8
Press GREEN.
NOTE:
• To activate the PIN, you must reset the receiver.
See page 25.
/ to change
• To restrict a specific channel, see "Child Lock" on
page 24.
• For information on resetting the PIN to the factory
preset "1234", see page 29.
• To change the PIN, enter a new PIN in this menu.

Reset Receiver

The Reset Receiver menu resets the DTV receiver.
1
Repeat steps 1 - 2 in "Installation" on page 24.
2
Press
OK. Press GREEN to confirm.
The digital receiver is reset. All channel lists are
removed and any user settings (DTV only) are reset to
the factory default.
3
The receiver will restart automatic installation at step
2. (See "Automatic installation (DTV)" on page 8.)
NOTE:
• Press RED to cancel.

About (software version)

The About menu provides television software version
information.
1
Repeat steps 1 - 2 in "Installation" on page 24.
2
Press

Conditional Access

If you are using a conditional access card, this setting
provides information about the card.
1
Press
access card, and then press OK.
NOTE:
• See page 30 for installation instructions.
/
/ to select Maturity Level. Press
to select the desired rating. See page 32.
/ to select Reset receiver, and then press
/ to select About, and then press OK.
/ to select the name of the conditional
25