Model Setting - Pioneer DVR-520H-S Service Manual

5

7.1.2 MODEL SETTING

• The Setup is Necessary When :
a) When the MAIN Assy is replaced
b) When the JCKB Assy is replaced
c) When the MAIN Assy and JCKB Assy are replaced
• How to Setup the Model
1) After power on, the following screen is displayed on TV monitor.
Press " 32 " by using the remote control unit for service(GGF1381).
[ Recorder 's Model Setting]
Input the number by using the remote for Service.
> --
Input No. Model
[ 32 : DVR-520H
[ 34 : DVR-720H
2) After 1), the following screen is displayed on TV monitor.
Press " 012 " by using the remote control unit for service.
[ Recorder 's Type Setting]
Input the number by using the remote for Service.
> ---
Input No. Type
[ 01 : WY
[ 02 : WV
The setting complete when OSD is disappeared.
3) Unplug the power cable.
4) Reset the recorder to all its factory settings.
1. Make sure that the recorder is on.
2. Press and hold [STOP] and press [STANDBY/ON] key on the front panel.
The recorder turns off with all settings reset.
5) Enter the Service Mode and then confirm the Model Name " DVR-520H/WY ".
1. Make sure that the recorder is on.
2. Press [ESC] then [DISP] keys by using the remote control unit for Service.
DVR-520H/WY
VERSION : 2.∗ ∗
SYSCON : RELEASE_44
Rev :1.3599.2.2
TUFLCON : 2.25 FLASH
DRIVE : DVD-RW DVR-107X
1.10K
CKT0000353WL
HDD : ST380012ACE
DEVICE : PRISM-PLUS
REGION : 2
: ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗ ∗
C
FLASH : 64M
Notes :
1) After the setting complete, you can NOT CLEAR the seting data.
Make sure the pressing number.
2) " NG " is appeared on TV when unsuitable number is pressed.
In such a case, please unplug the power cable and plug it again. Then restart the model setting.
5
6
]
]
(Type -- , Region No. -)
<Europe> ]
<UK> ]
$
OK
OK
OK
OK
80
6
7
Note : Make sure of setting the correct number.
Note : For 720H types, press " 34 ".
Note : For WV types, press " 022 ".
DVR-520H-S
7
8
A
B
C
D
E
F
81
8