Troubleshooting - AEG F55210VI0 User Manual

Table of Contents

Advertisement

8.4 To clean the external
surfaces
Clean the external surfaces of the
appliance and the control panel with a
moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive
cleaning pads or solvents (e.g. acetone).
8.5 Protecting against frost
Protect the appliance from frost, for
example in winter. After each cycle:

9. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
9.1 What to do if...
If the appliance does not start or it stops
during operation, before you contact an
Problem and alarm code
The appliance does not fill with water.
• The programme indicator ''Rinse &
Hold'' flashes very quickly.
• An intermittent acoustic signal
sounds for approximately 30 sec-
onds.
The anti-flood device is on.
• The programme indicator ''Deli-
cate 45°'' flashes very quickly.
• An intermittent acoustic signal
sounds for approximately 30 sec-
onds.
You cannot activate the appliance.
The programme does not start.
1. Disconnect the appliance from the
electrical supply.
2. Shut off water supply and disconnect
the water inlet pipe from the water
valve.
3. Drain water from the inlet pipe and
water valve.
4. Connect the water inlet pipe to the
water valve.
5. Remove the filter at the bottom of
the tub and use a sponge to collect
water from the sump.
Authorised Service Centre, check if you
can solve the problem by yourself with
the help of the information in the table.
With some problems programme
indicators flash intermittently indicating a
malfunction.
Possible solution
• Make sure that the water tap is open.
• Make sure that the pressure of the water sup-
ply is not too low. For this information, contact
your local water authority.
• Make sure that the water tap is not clogged.
• Close the water tap and contact an Authorised
Service Centre.
• Make sure that the mains plug is connected to
the mains socket.
• Make sure that there is no damaged fuse in
the fuse box.
• Make sure that the appliance door is closed.
• Press the start button.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
ENGLISH
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents