Table of Contents
Advertisement
2.2 Rear Panel
AC Power Mains: 220 to 240 V; 50 / 60 Hz
RF IN: For connection to cable from outdoor terrestrial antenna.
RF OUT: For connection to your TV antenna IN or Video Recorder RF IN.
S-VIDEO: Y/C video for connection to standard definition TV or Video Recorder.
VIDEO: Composite video output for connection to TV, Video Recorder or other A/V
Receiver.
AUDIO: Two sets of stereo audio outputs for connection to TV, Video Recorder or
other A/V Receiver.
YPbPr: Y/Pb/Pr component video for connection to high definition display.
RGB (15pin D): R/G/B/HS/VS video for connection to high definition display.
COAXIAL: Digital Audio output by coaxial for connection to AV processor.
OPTICAL: Digital Audio output by optical for connection to AV processor.
HDMI: Digital video and audio output for connection to high definition display.
USB Port: For software system maintenance (covered by sticker).
2.3 Box Contents
The box that contains your digital receiver should also contain the following items:
Remote Controller and batteries (AA Size)
RCA video cables (one white / red, and the other cable red / green / blue)
RF cable
User's Manual with Warranty Information
3
The Remote Controller
3.1 Preparing the Remote Controller
1
1). Remove the cover of the battery compartment (on the back of the handset) by
pushing the tab back and then lifting.
2) Insert 2 AA (1.5 V) batteries according to the + and – markings indicated inside
the battery compartment.
3) Replace the cover.
Test the remote controller by pressing any key and check if the IR-LED (Red) on the
front panel of the receiver flashes.
2
x
"AA"
Batteries
2
Operating Instructions
TU-HDT206A
3
5
Advertisement
Table of Contents
