Changing The Language Used For Display; Setting The Cutting Area - Roland PNC-1600 User Manual

2.5 Changing the Language Used for Display

The PNC-1900/1600 is capable of displaying all its menus in either of five languages, English, Japanese,
French, German and Spanish. To change the language that will be used, follow the steps below.
Procedure
1. While holding down the [ F1 ] key, turn the power ON.
2. The following message appears on the display. "Spanish" can be displayed by pressing the [ NEXT] key.
English
Japanese
3. This selects the language to be used. Press the [ F1 ] key to select "English," [ F2 ] for "German," [ F3 ] for
"Japanese," or [ F4 ] for "French." For "Spanish," press [ NEXT ] followed by the [ F1 ] key. When this
is finished, the top menu appears in the selected language. Display continues to be in the selected language
until this same procedure is carried out again.

2.6 Setting the Cutting Area

The cutting area of the PNC-1900/1600 is determined by setting a lower-left ( LL ) and upper-right
( UR ) value on the sheet. Be sure to make these settings before attempting cutting. When using the PNC-
1900/1600 for the first time, the LL value is set at the minimum of ( 0 , 0 ), and UR is set a t ( 41168 ,
36976 ) on the PNC-1900 and ( 3796 , 24784 ) on the PNC-1600.
When LL and UR have been set respectively as the lower-left and the upper-right, the X axis is horizontal
(left-right), and the Y axis is vertical. For normal horizontally written text, the characters are arranged
from left to right, as shown in figure 2-12.
[ NEXT ] key
German
French
→ ↑ → ← →
LL is lower left and UR is upper right
Y
LL
X
Figure 2-12
13
Spanish
※
※
UR