Audiovox Movies 2 Go MMD85A Operation Manual page 21

ACCESSORIES
WIRELESS HEADPHONES (Optional)
The MMD85A includes a built in infrared transmitter for use with Movies 2 Go wireless
headphones (PN MMIRHS). Turning the Wireless Headphone switch ON will activate
the internal IR receiver and the volume can then be adjusted separately with the controls
on each headset. Any number of wireless headphones can be used, but all must be
within direct line of sight from the transmitter. See the documentation accompanying
your Movies 2 Go wireless headphones for more detailed information.
Wired Headphones (Optional)
There are two 1/8" headphone jacks on the MMD85A that can be used with any standard
wired stereo headphones. These jacks are controlled by the volume up/down buttons on
the MMD85A remote control.
Wireless FM Modulator
The MMD85A is equipped with buit-in wireless FM Modulator*, that allows you to listen to the
MMD85A audio signal by tuning your vehicle's radio to the selected frequency, (88.3, 88.7,
89.1, 89.5, 89.9MHz). This feature is accessed by using the FM transmitter buttons on the
remote (ON/OFF, Channel Select). Whenever the FM modulator is on, broadcast reception
on the vehicles radio may be poor. Switching off the FM modulator will allow normal radio
reception.
:
*NOTE In certain areas where there are a large number of FM radio stations (e.g. large cities,
urban areas), the reception of the FM signal from the overhead pod may not be satisfactory,
resulting in static, distorted sound or signal bleed thru from strong local radio stations. This is
not a defect in the product, but the result of a stronger local radio station overpowering the
wireless FM transmitter in your overhead pod.
If wireless reception is unsatisfactory, an optional wired relay box (Audiovox P/N SIRSWB)
can be installed which will improve audio quality. Please contact the installer if this is the case
with your product.
MMD85A 21
1287460.P65 21 7/22/05, 4:00 PM