Panasonic TX-L32EM6B Operating Instructions Manual page 8

Attaching / removing the pedestal
Warning
Do not disassemble or modify the pedestal.
● Otherwise the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than the one provided with this TV.
● Otherwise the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
● If you use the pedestal while it is physically damaged, personal injury may result. Contact your local Panasonic
dealer immediately.
During set-up, make sure that all screws are securely tightened.
● If insufficient care is taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
Ensure that the TV does not fall over.
● If the TV is knocked or children climb onto the pedestal with the TV installed, the TV may fall over and personal injury
may result.
Two or more people are required to install and remove the TV.
● If two or more people are not present, the TV may be dropped, and personal injury may result.
When removing the pedestal from the TV, do not remove the pedestal by the methods other than the specified
procedure. (see below)
● Otherwise the TV and / or pedestal may fall over and become damaged, and personal injury may result.
Assembly screw (8)
M4 × 14
Assembly screws for base (4)
M4 × 10
Assembly screws for pedestal (4)
1
Place the TV screen face-down
on a cushioned, clean surface to
protect the screen from damages
and scratches.
8
Bracket
2
Assembling the pedestal
Use the assembly screws to fasten
the bracket to the base securely.
● Make sure that the screws are
securely tightened.
● Forcing the assembly screws the
wrong way will strip the threads.
M4 × 14
Front
3
Securing the TV
Adjust the position of the
A
pedestal, then insert the
pedestal to the TV screen.
Use the assembly screws to
B
fasten securely.
● Tighten the four assembly screws
loosely at first, then tighten them
firmly to fix securely.
● Carry out the work on a horizontal
and level surface.
M4 × 10
Hold the
bracket not
to fall over
A
Base
B