Sound 5 Center Geq (Center Graphic Equalizer); Sound 6 Hp Tone Ctrl; (Headphone Tone Control); Input 1 I/O Assign (Input/Output Assignment) - Yamaha RX-V340 Owner's Manual

SOUND 5 CENTER GEQ (center
graphic equalizer)
Use this feature to adjust the built-in 5-band graphic
equalizer so that the center speaker tonal quality matches
that of the left and right main speakers. You can select the
100 Hz, 300 Hz, 1 kHz, 3 kHz, or 10 kHz frequencies.
Control range (dB): –6 to +6
Initial setting: 0 dB for 5-band
1
Press d to select a higher frequency and u
to select a lower frequency.
2
Press –/+ to adjust the level of that
frequency.
Note
• You can monitor the center speaker sound while adjusting this
parameter by using the test tone. Press TEST before starting
the foregoing procedure. Once you begin this procedure, the
test tone remains at the center speaker and you can hear how
the sound changes as you adjust the various frequency levels.
To stop the test tone, press TEST.

SOUND 6 HP TONE CTRL

(headphone tone control)

Use this feature to adjust the level of the bass and treble
when you are using headphones.
Control range (dB):
BASS .................... –6 to +3
TRBL (treble) ....... –6 to +3
Initial setting:
BASS .................... 0 dB
TRBL .................... 0 dB
INPUT 1 I/O ASSIGN (input/
output assignment)
You can assign jacks according to the component to be
used if this unit's DIGITAL INPUT jack settings
(component names for jacks) differ from those of the
component. This lets you to change the jack assignment
and effectively connect more components.
Once assigned, select that component with INPUT l / h
(or the input selector buttons on the remote control).
I 1A for OPTICAL INPUT jack
(1) DVD, MD/CD-R, CD, VCR, V-AUX,
Choices:
D-TV/CBL
I 1B for COAXIAL INPUT jack
Choices: (2) CD, VCR, V-AUX, D-TV/CBL,
DVD, MD/CD-R
Note
• When you connect a component to both the COAXIAL and
OPTICAL jacks, priority is given to the input signals from the
COAXIAL jack.
INPUT 2 INPUT MODE
(initial input mode)
Use this feature to designate the input mode for sources
connected to the DIGITAL INPUT jacks when you turn
this unit on (see page 23 for details about the input
mode).
Choices: AUTO, LAST
AUTO
Select this setting to allow the unit to automatically detect
the type of input signal and select the appropriate input
mode.
LAST
Select this setting to set this unit to automatically select
the last input mode used for the respective sources.
SET MENU
43