Remote Control; Operating Other Components Using The Remote Control - Yamaha VS-10 Owner's Manual

REMOTE CONTROL

OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL

Setting the manufacturer code for your TV, VCR or satellite tuner/cable TV tuner on the remote control allows you to operate
not only the VS-10 but also your TV, VCR or satellite tuner/cable TV tuner using the remote control.
Notes
• Remote control of some component may not be possible depending on the model and the year of make even though its manufacturer is
listed on page i (at the end of this manual).
• Depending on the model, some components from other manufacturers cannot be controlled, or only limited functions can be controlled,
even though the proper manufacturer code has been set. If you encounter this problem, please use the remote control supplied with the
component.
• Setting the manufacture code can not be performed if your component to be controlled does not support remote control operation.
Setting the Manufacturer Code
ON/OFF
4
EFFECT
VS10 TV
–
VOL
MEMORY
1
4
7
MENU
–
- --
/
SUBWOOFER
–
NIGHT MODE
1
Press the remote control selector button (TV,
VCR or SAT) for which the manufacturer code
is to be set.
The signals for controlling the control center have
already been set for the VS10 button so that only the
manufacturer code for the TV, VCR or SAT needs to be
set. A manufacturer code of the TV, VCR or satellite
tuner/cable TV tuner can be set for the TV, VCR or
SAT button respectively.
Transmission
indicator
1
VCR SAT
P
+
VOL
2
P
SET
DSP INPUT
2 3
3
5 6
8 9
+
0
C/P
SUBWOOFER
+
TEST
2
Hold down SET and press c until the
transmission indicator lights.
3
While the transmission indicator is lit, enter
the 4-digit manufacturer code for the
component to be controlled using the numeric
buttons.
1 2 3
4 5 6
7 8 9
0
Enter the code surely. The transmission indicator goes
out when the code is set properly. (The code has not
been set properly if the indicator flashes and then goes
out.)
Refer to the list of manufacturer codes on page i (at the
end of this manual).
4
Press p and check that the component to be
controlled turns on and off.
The indicator will light.
The indicator will go out.
27