Table of Contents
Advertisement
• Opening the SETUP menu
Press the PAGE button for a few seconds.
CAMERA ID
FLD/FRM
ELC
SHUTTER
GAIN
SYNC
BLACK BAL
SCENE FILE
END
• Editing the SETUP menu
To edit the SETUP menu (change settings), press the
ITEM button to move the cursor to an item, and press
A and B to change its parameter. After completing all
the settings, move the cursor to END at the bottom
line, and press the PAGE button. The new values are
stored in the EEPROM (Electric Erasable and
Programmable Read Only memory). These values
remain valid until new values are stored, even if the
power of the camera control unit is off.
CAMERA ID
FLD/FRM
ELC
SHUTTER
GAIN
SYNC
BLACK BAL
SCENE FILE
END
12
** SET UP **
*OFF
FLD
*OFF
OFF
AUTO
INT
ABC
*SCENE1
** SET UP **
*OFF
FLD
*OFF
OFF
AUTO
INT
ABC
*SCENE1
• All Reset Operation
All Reset allows you to reset all setup menu items to
the factory settings if you are unsure about the correct
settings. Proceed as follows:
1. Repeat the above procedures to display the
SETUP menu.
2. Move the cursor to END at the bottom line.
3. Press both A and B for a few seconds. The
SETUP menu disappears on the monitor screen
and the auto warning indicator lights red.
At this time, all adjustments and parameters are reset
to the factory default settings. The auto warning indica-
tor goes off if AWC or ABC is performed.
Advertisement
Table of Contents
