Mechanical Instructions - Dell E178FPC Service Manual

17" LCD Color Monitor

6. Mechanical Instructions

Tools: 2 Power screwdrivers (φ=5mm,L=60mm); 1 small cross screwdriver; turnbuckle driver;
Setting: Power screwdriver torque A=11 kgF. Cm; torque B=6 kgF. Cm
Note: Firstly, put the monitor on a soft, flat and clean surface, wear gloves.
Fig
27
Dell E178FPC
Remark
Remove stand:
1. Rotate the stand to allow access
to the stand release button.
2. Press the Stand release button
and lift up the Stand and away from
the monitor.
Remove rear cover :
1. Remove the 4 screws by
A
2. Pry the monitor up then find out
the hooks' position, use the tool
(like the picture or other card) to
insert into the gap of bezel and
rear cover.
torque