Table of Contents
Advertisement
CONNECTIONS
Connection C
Good Picture and Sound Quality
To use this connection you must have:
•
TV with RF input (jack)
•
VCR with RF and audio/video inputs
•
Coaxial and audio/video cables
To connect TV, VCR, and antenna or cable box.
1. Connect coaxial cables and audio/video cables as shown.
To receive DSS
®
•
Tune TV to channel 3 or 4 (depending on how you set the
CH3/CH4 switch on the back of the receiver).
To receive off-air programming (no cable box):
1. Turn off VCR and satellite receiver.
2. Tune TV to desired channel.
To receive cable programming (with cable box):
1. Turn off VCR and satellite receiver.
2. Tune TV to cable box output channel (usually CH2, CH3,
or CH4).
3. Tune cable box to desired channel.
®
To record DSS
programming:
1. Tune TV to the channel on which you receive the DSS
signal.
2. Tune satellite receiver to desired channel.
3. Set VCR to record on line input.
To view VCR programming:
1. Tune TV to VCR output channel (usually CH3 or CH4).
2. Turn satellite receiver off.
38
programming:
TV
IN
DSS
OUT TO TV
RECEIVER
IN FROM ANT
VCR
IN FROM ANT
CH3
CH4
OUT TO TV
®
CAUTION
Do not stack electronic components
or other objects on top of the DSS
Receiver. The slots on top of the
receiver must be left uncovered to
allow proper airflow to the unit.
Blocking the airflow to the unit could
impair performance or damage your
receiver and other components.
Do not stack the DSS receiver on
top of a "hot component" such as an
audio power amplifier.
SATELLITE
DISH
VIDEO
R
L
AUDIO
CABLE
SATELLITE IN
CH4
R
L
OR
VIDEO
CH3
AUDIO
OFF-AIR ANTENNA
VIDEO IN
AUDIO IN
R
L
VIDEO OUT
AUDIO OUT
Advertisement
Table of Contents
