PICTURE menu
Remote control
See "Navigating through the MENU" on page 27.
See "Main menu and Sub-menu" on page 28.
PICTURE MODE
Depending on the projection environment, you can use
these preset parameter settings to optimize image
projection. Press I H to cycle through the options.
NATURAL
STANDARD
DYNAMIC
BLACKBOARD
NOTE:
• The default setting varies according to the selected
signal.
• It may take for a while until the selected mode is
stabilised.
CONTRAST
You can adjust the contrast of the projected image.
Adjust the BRIGHTNESS in advance if necessary.
Lower
BRIGHTNESS
You can adjust the brightness of the projected image.
Darker
E
NGLISH - 30
Control panel
MENU
RETURN
Reproduces the original color of
the image
Setting for a general image
Bright and sharp setting
Setting for when projecting on a
blackboard
See "BLACKBOARD" on
page 37.
Higher
Brighter
COLOR
You can adjust the color saturation of the projected
image. (Available with signals of VIDEO/S-VIDEO/
YP
P
only)
B
R
Lighter
TINT
You can adjust the skin tone in the projected image.
(Available with signals of VIDEO/S-VIDEO/YP
More
reddish
SHARPNESS
You can adjust the sharpness of the projected image and
the adjustable range depends on the input signal.
Less
sharp
COLOR TEMPERATURE
You can adjust the white balance of the projected image.
Press I H to cycle through the options.
STANDARD
Balanced white
HIGH
More bluish
LOW
More reddish
DAYLIGHT VIEW
You can keep the projected image bright and vivid even
in well-lit rooms where the ambient light sources cannot
be controlled, such as when a door opens or when
window coverings fail to block out sunlight.
AUTO:
Automatic adjustment
ON:
Active
OFF:
Deactive
NOTE:
• Do not cover the Ambient Luminance Sensor (ALS) of
the projector. See "Ambient Luminance Sensor (ALS)"
on page 12.
• AUTO is not available when INSTALLATION setting in
OPTION menu is set to REAR/DESK or
REAR/CEILING.
Darker
P
only)
B
R
More
greenish
More
sharp