Table of Contents
Advertisement
Appendix
Technical Information
Ceiling mount bracket safeguards
The projector and the ceiling mount bracket are designed for sufficient safety. However, make sure the safety cable
provided with the projector is installed and attached to the bottom of the projector when mounting on the ceiling for
safety and security.
Make sure to use a torque driver and do not use an electrical screwdriver or an impact screwdriver.
NOTE:
•
Even if it is during guaranteed period, the manufacturer is not responsible for any hazard or damage caused by using a
ceiling mount bracket which is not purchased from an authorized distributors, or environmental conditions.
•
Installation work of the ceiling mount bracket should only be carried by a qualified technician.
•
Remove an unused ceiling mount bracket promptly.
Installing the safety cable
J
1.
Install the ceiling mount bracket according to the Installation Instructions.
2.
Loop the safety cable around the ceiling mount bracket with less slack.
Lace the cable of the end with a latch through the loop on the other end of the cable.
Loop once
* Indicated above is ET-PKE1000S.
3.
Attach the latch on to the bottom of the projector with a provided screw.
E
30 -
NGLISH
M4×0.7
9 mm
Torque: 1.25 ± 0.2 N·m
Loop twice
* Indicated above is ET-PKE2000.
M4×0.7
9 mm
Torque: 1.25 ± 0.2 N·m
Hide quick links:
Advertisement
Chapters
Table of Contents
