Table of Contents
Advertisement
Dimensions
R/P
R
G/Y
B/P
B
SYNC/HD
VD
VIDEO IN
S-VIDEO IN
RGB 1 IN
RGB 2 IN
REMOTE 1
REMOTE 2 IN
IN
SERIAL
OUT
IN
OUT
Installation dimensions diagram
(Figure 1 : Dimensions applying when one unit is used)
Exhaust
• Leave a clearance of at least 50 cm (19.7") so that the ventilation opening on the rear panel will
Attention
not be blocked.
• Be careful not to retain exhausted air on the back side of the main unit. Also take steps to ensure
that the hot air blown out from the air exhaust outlet will not be sucked into the air intake.
• Install with clearances of at least 30 cm (11.8") provided for the side panels to enable the air filter
to be removed and re-installed.
• When operating the projector in an enclosure, ensure that the temperature of the surrounding air
within the enclosure remains within the range 0 °C to 40 °C while the projector is running. Also
ensure that the air intake and exhaust vents are unobstructed. Even when the surrounding air
temperature is maintained below 40 °C, operation of the protection circuit could cause a shutdown
due to hot exhaust air being trapped inside the projector. When designing the enclosure, please
give due consideration to the thermal environment surrounding the projector (Figure 2).
DVI-D IN
LAN
>PC<
TBMU448
50 cm (19.7")
or more
478.5 (18
27
/
)
32
436 (17
11
/
)
64
530 (20
55
/
)
64
(Figure 2 : Dimensions applying when two units are used)
Exhaust
50 cm (19.7")
or more
50 cm (19.7")
or more
Exhaust
unit : mm, ( ) : inch
50 cm (19.7")
or more
10 cm (3.9") or more
63
Hide quick links:
Advertisement
Table of Contents
