Advertisement
Using Your Kambrook Blender
NOTE: The grinding blade
is designed for grinding dry
ingredients only. Do not add
any liquid when using the
grinding blade.
NOTE: Do not use the grinding
blade to make pastes of any
fruits, seeds or herbs i.e. curry
pastes or nut butters.
NOTE: Do not use the grinding
blade for grinding sticky or
extremely hard ingredients,
such as chocolate, whole
nutmeg, candied fruits, etc.
NOTE: Do not use the BlitzPro
grinding blade to crush ice
cubes. Ice cubes may be
blended using the blending
blade with liquid content added
as per the recipes in this book.
NOTE: Do not exceed the 350ml
maximum marking on the
smaller cup.
12
continued
3.
Screw the grinding blade holder
to the 350ml cup by turning the
blade holder in a clockwise
direction. Make sure that the
grinding blade holder is securely
tightened to the cup (See Fig. 9).
Fig. 9
4. With the ingredients inside and
the grinding blade holder
screwed on, flip the cup so that
the blade holder is facing down
(See Fig. 10).
Fig. 10
5. Plug the power cord into a 230V
or 240V power outlet and switch
on at the power point.
6. With one hand on the motor base
and the other hand holding the
assembled cup, place the cup
inside the motor base by aligning
the three tabs on the cups with
the three slots on the motor base
(See Fig. 11).
Fig. 11
7.
To grind, press down and turn the
assembled cup clockwise in the
direction of the 'ON' symbol on
the motor base. The cup will lock
inside the motor base and the
blender will operate.
Fig. 12
NOTE: The BlitzPro Blender will
not operate unless the three
locking tabs on the cup are
properly fitted into the three
slots on the motor base.
WARNING: Do not
operate the motor
continuously for more
than 30 seconds at a
time. Allow the motor
to rest for 2 minutes
before continuing.
8.
When grinding is complete, hold
the motor base with hand and
with the other hand turn the
assembled cup anti-clockwise
in the direction of the 'OFF'
symbol on the motor base. Lift the
assembled cup from the motor
base to remove.
9.
Flip the cup so the blade holder is
at the top (See Fig. 13).
Fig. 13
10. Carefully unscrew and remove
the grinding blade holder from the
cup by turning the blade holder in
an anti-clockwise direction. Avoid
touching the sharp blades.
13
Advertisement
