Honda 1998 Odyssey Owner's Manual page 55

Indicator Lights, Gauges
"Daytime Running
DRL
Lights" Indicator
Canadian models only
This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch off and the
parking brake set. It should go off if
you turn on the headlights or release
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
Cruise Control Indicator
CRUISE
CONTROL
This lights when you set the cruise
control. See page 64 for information
on operating the cruise control.
Instruments and Controls
High Beam Indicator
This light comes on with the high
beam headlights. See page
information on the headlight
controls.
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page 58).
Immobilizer System
Indicator
This indicator comes on for a few
seconds when you turn the ignition
switch ON (II). It will then go off if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page 68).
This indicator also blinks several
times when you turn the ignition
switch from ON (II) to ACCESSORY
(I) or LOCK (0).
Tachometer
40 for The tachometer shows the engine
speed in revolutions per minute
(rpm). To protect the engine from
damage, never drive with the
tachometer needle in the red zone.
Trip Meter
This meter shows the number of
miles (U.S.) or kilometers (Canada)
driven since you last reset it.
There are two trip meters, Trip A
and Trip B. Each trip meter works
independently, so you can keep track
of two different distances.
To reset a trip meter, display it and
then press the Reset button for more
than two seconds. Both trip meters
will reset if the vehicle's battery goes
dead or is disconnected.