Volvo 2007 S80 Owner's Manual page 77

The use of daytime running lights is mandatory in Canada.
Continuous high beams cannot be activated when the headlight switch is in position
flash will function in these positions.
High beam flash
Move the lever toward the steering wheel to position
High/low beam headlights
Continuous high beams
Set the ignition to mode II.
With the light switch in position
between high and low beams (this also applies on models equipped with the optional Active Bi-Xenon headlights).
The symbol illuminates in the instrument panel to indicate that the high beams are on.
85
03 Your driving environment
Lighting
NOTE
Active Bi-Xenon headlights (option): Turn the headlight switch to position
automatically switches the low beams on or off, depending on ambient light conditions. When driving in daylight,
the headlights will switch off and the daytime running lights will come on. In darkness, the daytime running lights
will switch off and the Active Bi-Xenon headlights will switch on.
Active Bi-Xenon Lights (ABL)-option
When the ABL function is activated, the headlight beams adjust laterally to help light up a curve according to
movements of the steering wheel (see the right-pointing beam in the illustration above).
This function is activated automatically when the engine is started and can be deactivated/ reactivated by pressing the
ABL button in the center console.
NOTE
This function is only active in twilight or dark conditions, and only when the vehicle is in motion.
. The high beams come on until the lever is released.
, pull the turn signal lever toward the steering wheel to position
or . High beam
to activate a daylight sensor, which
to toggle