Cassettes; Tips On Recording - Panasonic RX-ES20 Operating Instructions Manual

TAPE CD
7 7
1 2
7
3
7
1
Side to be played back facing up
7
Insert the cassette with the exposed tape facing you.
2
7
3
7
A
SLEEP TIMER FADER DISPLAY
1 2 3
4 5 6
7 8 9
FM MODE/BP C RESET RANDOM
PRESET EQ
TAPE TUNER
a
b
c
DISPLAY
PGM/-CLEAR
10
0
REPEAT
C RESET
CD

Cassettes

Press [0 DECK] to open the deck.
1
(The unit comes on.)
Load a cassette and close the deck by hand.
-
Press [ TAPE] to start play.
2
Press [+, – VOLUME] to adjust the volume.
3
To stop play:
Press [n TAPE/CD].
One touch play
(When using AC power)
When a cassette is loaded, press [
The unit comes on and play starts.
Fast-forward and rewind
Press [REW / – / Q] (rewind) or [R / + / FF] (fast-forward).
On the remote control
Press [REW / –] (rewind) or [+ / FF] (fast-forward).
Selection of tapes
Use normal position tapes to play correctly.
High position and metal position tapes can be played, but the unit will
not be able to do full justice to the characteristics of these tapes.
Cassette tape care
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Tape slack can get caught up in the mechanism and should be
taken up before the tape is played.
• Endless tapes can get caught up in the deck's moving parts if used
incorrectly.

Tips on Recording

Your attention is drawn to the fact that recording pre-record-
ed tapes or discs or other published or broadcast material
may infringe copyright laws.
Use household AC power or new batteries when recording to avoid
poor recordings caused by the batteries running down.
Televisions can cause interference to recordings made on this unit
if the two are too close to each other.
Selection of tapes for recording
Use normal position tapes.
High position and metal position tapes can be used, but the unit will
not be able to record or erase them correctly.
Volume and sound quality in recording
• Recording level is set automatically.
• Recording are unaffected by changes to sound quality.
A
To display the tape counter while recording
Remote control only
Press [DISPLAY].
Each time you press the button in the CD or radio mode:
a b
Present state Present time
To reset the tape counter
Press [C-RESET].
The counter resets to "000".
-
TAPE].
c
Tape counter
13
RQT5189