Honda 2003 Civic Hybrid Owner's Manual page 236

Replacing Rear Bulbs
(in Fenders)
FASTENERS
1. Open the trunk.
Remove the screws in the center
of each of the two fasteners on the
side of the trunk lining. Pull the
lining back.
2. Determine which of the two bulbs
is burned out: stop/taillight/side
marker light or turn signal light.
3. Remove the socket by turning it
one-quarter turn counterclockwise.
4. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
5. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Test the lights to make sure the
6.
new bulb is working.
7. Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
8. Put the fasteners into the holes on
the side of the trunk lining.
Reinstall the screws.
Maintenance
Lights
237