Rinnai Energysavers RHFE-1005FT Operation And Installation Manual page 22

Install flue
1. Install the flue as per the instructions in the
Energysaver flue installation manual.
2. Return the Energysaver to its final position
and connect to the flue.
3. Connect gas supply line and fully tighten
connection. Use a soapy solution to test all
gas connections. If a leak is present bubbles
will form at the leak point. When finished
remove any residue with a rag. Prevent any
soapy solution from coming into contact with
the electrical components.
Fit the rear panels
The rear panels are NOT an optional component
and MUST BE fitted to ensure the correct and safe
operation of the appliance while also providing
concealment and protection of the flue and gas
connections. Failure to fit the panels will void any
warranty.
1. Fit the left and right cover panels to the rear
of the appliance by clipping the panels onto
the location tabs, then fastening into position
using the two 6 g x 8 mm self tapping screws.
These screws located into the pre-drilled and
formed recesses of the panels and appliance.
N.B: The 1005FT model, in addition to the
above step, also requires securing into the two
side panel brackets, refer image below.
Side rear panels 309, 559, 561FT
Side rear panels 1005FT
22 | Energysaver operation and installation guide 02-15
2. Remove the fan filter(s).
3. Carefully fit the top cover panel ensuring
4. Replace the filter(s).
Side panel brackets
the rear fold locates neatly between the two
securing brackets and the wall. Secure the
top cover panel with the 6 g x 8 mm pan head
screws supplied (2 for the 309, 559, 561FT, and 3
for the 1005FT).