Toyota 2009 Camry Quick Reference Manual page 317

After changing the engine oil (U.S.A. only)
n
To reset the oil change system, follow the procedure below:
STEP 1
Turn off the hybrid system with the trip meter A reading shown.
(→P. 145)
STEP 2
The "POWER" switch must be set in ON mode while holding down
the trip meter reset knob. A message "OIL MILEAGE RESET MODE" will
appear on the display.
STEP 3
Hold down the knob for at least 5 seconds. A message "COM-
PLETE" will appear and the message "OIL MILEAGE RESET MODE" goes
off.
CAUTION
Used engine oil
n
Used engine oil contains potentially harmful contaminants which may
l
cause skin disorders such as inflammation or skin cancer, so care should
be taken to avoid prolonged and repeated contact. To remove used engine
oil from your skin, wash thoroughly with soap and water.
l Dispose of used oil and filters only in a safe and acceptable manner. Do
not dispose of used oil and filters in household trash, in sewers or onto the
ground. Call your Toyota dealer, service station or auto parts store for
information concerning recycling or disposal.
Do not leave used engine oil within the reach of children.
l
NOTICE
To prevent serious engine damage
n
Check the oil level on a regular basis.
n When replacing the engine oil
Be careful not to spill engine oil on the vehicle components.
l
Avoid overfilling, as the engine could be damaged.
l
Check the oil level on the dipstick every time you refill the vehicle.
l
Be sure the engine oil filler cap is properly tightened.
l
4-3. Do-it-yourself maintenance
4
295