Other Connection Methods; Connecting Through The Access Point; When Logging On Without Administrator Authority - Panasonic TY-FB10WPU Operating Instructions Manual

Other Connection Methods

Connecting through the access point

You can make the setting for infrastructure mode* (connection through the access point); however, confirm to your system
administrator on network settings before changing any settings. (See page 44) * "Glossary" (See page 55)
1
First connect the unit to the computer.
2 Start the WEB browser control and make network settings under [Network] on the
menu.
Make infrastructure mode settings for [USER1] to [USER3]. (See page 44)
3
Exit Wireless Manager ME 4.0 running on the computer.
4
Make computer settings following the instructions of the network administrator.
5
Connect to the access point*.
* "Glossary" (See page 54)
6
Start Wireless Manager ME 4.0, click [Wireless LAN] on the [Network Adapter Selection]
screen, and then select the network adaptor connected to the access point.
* If a confirmation screen asking if you wish to switch to the projector network appears, select [No].
7
On the [Select Connection Target] – [Details] screen, click the network number set
in Step 2, select the unit to be connected, and click [OK].
The launcher appears and the connection with the unit is established. ("Description of the launcher" →See page 22)
Note
If the unit is not displayed, click [Designate] followed by [ADD], then enter the IP address set in the unit using the "Access Port
Registration" window, and click [REGISTER]. (See page 20)

When logging on without administrator authority

To connect without PC administrator rights, the appropriate settings under "Computer Settings" must first be made beforehand
by someone with PC administrator rights.
Next, logon as a restricted user or [GUEST], and start Wireless Manager ME 4.0.
Confirm to your system administrator before changing any settings.
The example below is for when the unit is being used under default settings.
1
Connect the unit to the computer as the computer administrator.
2
Start WEB browser control and make network settings using [USER1] to [USER3]
under [Network] on the menu.
DHCP*
IP ADDRESS*
SUBNETMASK*
SSID*
MODE
AUTHENTICATION
ENCRYPTION
ENCRYPTION KEY
SETTING
* "Glossary" (See page 54, 55)
(See page 44)
OFF
192.168.10.100
255.255.255.0
Panasonic Display
AD HOC*
OPEN* (Some computers may require connection by [SHARED*] authentication.)
NONE...When not performing encryption
WEP...When performing encryption
When [ENCRYPTION] setting is [WEP*]:
DEFAULT KEY : Set 1 – 4 numerals for the default key.
KEY 1 – 4 : Set these to match the WEP key registered in [DEFAULT KEY].
(See page 14)
51