Table of Contents
Advertisement
Other operations for connection
Operations when password entry is required for connection
When a unit with the [ ] mark is selected, the window shown to the right appears. Enter the password
and click [OK].
(See page 48)
Notes
• Click [CANCEL] at the password entry window to return to launcher (See page 22).
• When an incorrect password is entered, an error message appears. Click [OK] to return to the password entry window and
enter the correct password again.
Adding and deleting connections
When [Network] is set to [U] and the desired unit is not displayed at the "Select Access Port" window, connections can be added
and deleted by the following operations.
Adding a connection
1
Click [Designate] at the "Select Access Port" window.
The window shown to the right appears.
2
Click [ADD] and enter the IP address* (including its periods) of the
connection to be added, and then click [REGISTER].
* "Glossary" (See page 54)
The newly registered connection is added to the connection list in the window shown in step 1.
Deleting a connection
Select the connection to be deleted at the window shown in step 1 and click [DELETE].
(cont.)
20
Advertisement
Table of Contents
