Electrolux EWX 127410 W User Manual page 33

Fix the hinges to the appliance by means of
the M5x15 screws. The hinges can be ad-
justed to compensate for possible uneven
thickness of the door.
To align the door perfectly it is necessary to
loosen the screw, adjust the door and tight-
en the screw A again (Fig. 5).
Warning! Do not remove the screw B
(Fig. 5).
Fig. 5
B
d) Counter-magnet
The appliance is prearranged for a magnet-
ic closure of the door.
To enable a correct operation of this device,
it is necessary to screw the counter-magnet
A (steel disk + rubber ring) into the inner
side of the door. Its position must corre-
spond to the magnet B on the appliance
(Fig. 6).
Warning! Do not remove the screw C.
Fig. 6
If the door has to be opened from left to
right, invert the position of the plates E, the
magnet D and the plate C. Mount the
counter-magnet D and the hinges A as pre-
viously described (Fig. 7).
Warning! Do not remove the screw B.
A
A
B
C
Fig. 7
E
Recommendations regarding the con-
struction and fitting of a base when the
installation requires an integrated ap-
pliance to be raised.
Where the appliance has been raised by
mounting onto a wooden base provided by
the installer. The material used to construct
the base should have anon slip surface, be
water repellent and if possible be one solid
piece.
If it is not possible to use one solid piece,
due to the additional height required, en-
sure that any additional strips of timber are
glued and screwed to the underside of the
base (see Fig. 8).
8
5 mm Hardwood strip
Front view
Drill four fixing holes (see Fig. 9).
electrolux 33
D
A
C
B
Additional pieces of
timber should run
from front to back