Electrolux EWX 127410 W User Manual page 27

4. Slide out the relevant plastic spacers.
5. Fill the smaller upper hole and the two
large ones with the corresponding plas-
tic plug caps supplied in the bag con-
taining the instruction booklet.
POSITIONING
Install the machine on a flat hard floor.
Make sure that air circulation around the
machine is not impeded by carpets, rugs
etc. Check that the machine does not
touch the wall or other kitchen units. Level
the washing machine by raising or lowering
the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the
machine MUST be level and stable. If nec-
essary, check the setting with a spirit level.
Any necessary adjustment can be made
with a spanner.
Accurate levelling prevents vibration, noise
and displacement of the machine during
operation.
Caution! Never place cardboard,
wood or similar materials under the
machine to compensate for any
unevenness in the floor. After having
levelled the appliance, tighten the lock
nuts.
RAISING THE APPLIANCE
Suspended wooden floors are particularly
susceptible to vibration.
To help prevent vibration we recommend
you place a waterproof wood panel, at least
15 mm thick under the appliance, secured
to at least 2 floor beams with screws, the
wood panel must extend beyond the front
feet.
If possible install the appliance in one of the
corners of the room, where the floor is
more stable.
WATER INLET
An inlet hose is supplied and can been
found inside the machine drum. Do not use
the hose from your previous machine to
connect to the water supply.
Important! This appliance must be con-
nected to a cold water supply.
1. Open the porthole and extract the inlet
hose.
electrolux 27