A Fault Message Appears In The Display - Miele PW 6080 Vario Operating And Installation Instructions

Problem solving guide

A fault message appears in the display

Message
p
Water intake fault
Open the stopcock
and
check the inlet hose.
,
Technical fault
,
Fault
Disinfection
temperature
not reached
q
Drain fault
Clean the drainage
system.
Fill the container
or
O
Fault
Container empty
A To switch off the fault message, press the multi function selector.
42
Possible cause
The water inlet is
blocked or restricted.
The water pressure is
too low.
There is a fault.
During the disinfection
programme the water
temperature was not
reached.
The water outlet is
blocked or restricted.
One of the external
detergent containers is
empty.
Remedy A
Check whether
– the stopcock is opened
enough.
– the inlet hose is kinked.
– Select Low water
pressure in the
Settings/Supervisor level
menu.
Start the programme again.
If the fault message appears
again, contact the Miele Ser-
vice Department.
The machine has not
carried out the disinfection
cycle correctly.
Start the programme again.
Drain pump version: Clean
the drainage system.
Drain valve version: Call
Service.
See "Detergent - Empty
sensor".