Using The [Remote] Connector (Euroblock 3-Pin) - Yamaha MA2120 Setup Manual

Using the [REMOTE] Connector (Euroblock 3-pin)

You can connect switches to the rear panel [REMOTE] connector, and use them to remotely mute/unmute outputs of all channels, or
switch the power standby/on status.
From the left, the [REMOTE] connector consists of M (mute all), S (standby), and G (ground) pins.
The [REMOTE] connector uses a Euroblock plug. For details on how to connect Euroblock plugs, refer to "Attaching Euroblock Plugs."
Muting/unmuting all channels
Turning mute on
NOTE
• When the device is put into standby mode via the [REMOTE] connector, it is not possible to turn the power back on by pressing the
[z] button on the front panel, or by the auto-wake function with input signal detection. The power can only be turned on via the
[REMOTE] connector.
• When the device is put into mute mode via the [REMOTE] connector, the [z] button will flash in green.
Switching the power standby/on status
Turning mute off Switching the power to standby
Connections
Turning the power on
7
MA2120 Setup Guide