Advertisement
Targus Plug-N-Power Charging Station with USB Charging Ports
Screw Mounted Installation
Some wall outlet face plates have a center screw hole which can be utilized
for a more permanent installation. While this is not necessary for normal
use of the Charging Station, it offers a more secure form of mounting.
1. Remove the original screw in the center of the face plate, making sure
to leave the face plate in place.
2. Install the Charging Station as indicated above for Normal Installation.
3.Using the long center screw that came with the Plug-N-Power
Charging Station, screw the Charging Station into place with a philips
head screwdriver.
4
Targus Plug-N-Power Charging Station with USB Charging Ports
Technical Support
For technical questions, please visit:
US
Internet: www.targus.com/support.asp
Note: Compatible with most 5 volt tablets. Some tablets require the use of a USB
charging dongle, available for free from Targus.com when you register your product.
Product Registration
Targus recommends that you register your Targus accessory shortly after purchasing it. To
register your Targus accessory, go to:
http://www.targus.com/registration.asp
You will need to provide your full name, email address, country of residence and product
information.
Warranty
Targus warrants this product to be free from defects in materials and workmanship for two
years. If your Targus accessory is found to be defective within that time, we will promptly
repair or replace it. This warranty does not cover accidental damage, wear and tear, or
consequential or incidental loss. Under no conditions is Targus liable for loss of, or damage
to, a computer or other device(s); nor loss of, or damage to, programs, records, or data;
nor any consequential or incidental damages, even if Targus has been informed of their
possibility. This warranty does not affect your statutory rights.
Regulatory Compliance
(applicable to products with electronic circuitry/parts only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may notcause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
5
Advertisement
