Input Cis Dot & Adjust The Shutter Speed (Adj_01) - Samsung nx10 Service Manual

Adjustment
5-4 Input CIS DOT & Adjust the Shutter Speed (ADJ_01)
■ When you change the MAIN PCB or CMOS, you need to input the DOT value of CMOS on the EEPROM.
■ You must do the Shutter speed adjustment after changing the Shutter ASS'Y or Main PCB.
<How to adjust>
1. Connect to PC and Shutter Speed adjustment tool by using usb cable.
2. Connect to PC to your camera by using USB cable and turn on the camera.
3. Change the setting on the tester mode as below.
- TEST MODE : Left → OK → Right → Ev + OK button at the same time.
- 3. Select the ADJUSTMENT CONTROL.
- (2) LINE PROCESS STEP value is 01.
- (3) LINE PROCESS MARK value is Off.
4. Please run NX-Shutter Speed adjustment program after insert the SD Card which contain the adjustment file.
5. Press the send ( ) button after input CMOS S/N on the Serial section of MAIN PCB.
q
6. You can find the result of CMOS DOT on the right side as a (
* If total defects of B, O, T are over 1000, it may display NG.
5-4
154
q
<NX-Shutter Speed Adjust Program>
This Document can not be used without Samsung's authorization
Fig. 5-3
).
w
w
CMOS S/N
Fig. 5-4
SAMSUNG