Aoutside Top Exhaust; Attach Mounting Plate To Wall; Installation Overview - GE pvm9179 Installation Instructions Manual

A OUTSIDE TOP EXHAUST

INSTALLATION OVERVIEW

A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Check Blower Motor Oientation
A4. Adapt Blower for Outside Ventilation
A5. Check Damper Operation
A6. Mount Microwave Oven
A7. Adjust Exhaust Adaptor
A8. Connect Ductwork
ATTACH THE MOUNTING PLATE
A1
TO THE WALL
A
C
Attach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach the plate to
a wall stud. Recommended locations on the mounting
plate are indicated by A, B, C and D.
1 Remove the toggle wings from the bolts.
2
Insert the bolts into the mounting plate through
the holes designated to go into drywall and reattach
the toggle wings to
3 4
Installation Instructions
B
D
onto each bolt.
(Vertical Duct)
To use toggle bolts:
Mounting
Plate
Place the mounting plate against the wall and insert
3
the toggle wings into the holes in the wall
to mount the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch the
bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION
fingers between the back of the mounting plate
and the wall.
Tighten all bolts. Pull the plate away from the wall to
4
help tighten the bolts.
12
Spacing for
Toggles More Than
Wall Thickness
Toggle Wings
Toggle
Bolt
Wall
Bolt End
Be careful to avoid pinching