How To Use The Hr085 Remote Control - McIntosh C2600 Owner's Manual

Hide thumbs Also See for C2600:

Service manual (50 pages)

Table Of Contents

Table of Contents

How to use the Remote Control

The supplied C2600 Remote Control (HR085) is ca-

pable of directly controlling the functions of contem-

porary McIntosh Source Components connected to the

C2600 via the Data Ports.

Notes: 1. If at any time the C2600 seems unresponsive

to the HR085 Remote Control Commands,

press the

DEVICE Push-button to select

first.

2. For additional information on using the

HR085 Remote Control with the McIntosh

Model, please refer to the "How to Operate"

starting on page 20.

3. For additional information on assigning the

Data Ports, refer to "How to Setup" on page

16.

Trim

Press the TRIM Push-button until the desired Trim

function (Balance, Trim Level, etc.) appears on the

C2600 Front Panel Display, then press the LEVEL Up

or Down Push-button to adjust the Trim setting.

Note: Press the TRIM Push-button to recall the last Trim

function selected. For additional information on

using the Trim Functions refer to "How to Oper-

ate" page 20.

Output Selection

Press the BLUE (Setup) Push-button followed by

the AM (Output 1) or FM (Output 2) Push-button, to

control the Rear Panel Audio OUTPUTS 1, 2 (ON or

OFF) and Power Control TRIG 1 / TRIG 2.

Note: For additional information on assigning the Out-

puts (1 and 2) and Power Control Triggers (1 and

2) refer to page 16.