System Settings - Pioneer DEH-X3900BT Owner's Manual

Menu Item
LOUDNESS
[OFF], [LOW], [MID], [HI]
SUB.W*2
[NOR], [REV], [OFF]
SUB.W CTRL*2*3
Cut-off frequency: [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level: [–24] to [+6]
Slope level: [–12], [–24]
BASS BOOST
[0] to [+6]
HPF SETTING
Cut-off frequency: [OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level: [–12], [–24]
SLA
[+4] to [–4]
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 6).
*3 Not available when [OFF] is selected in [SUB.W].

SYSTEM settings

You can also access to these menus when the unit is turned off.
Menu Item
CLOCK SET
16
En
Description
Compensate for clear sound at low volume.
Select the subwoofer phase.
Only frequencies lower than those in the
selected range are output from the subwoofer.
Select the bass boost level.
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
• When making a USB connection, set USB, iPod,
PANDORA, ANDROID, SPOTIFY, and APP.
• When making a Bluetooth connection, set BT
AUDIO, PANDORA, ANDROID, SPOTIFY, and
APP.
Description
Set the clock (page 5).
Menu Item
12H/24H
[12H], [24H]
AUX
[ON], [OFF]
BT AUDIO
[ON], [OFF]
SPOTIFY
[ON], [OFF]
BT MEM CLEAR
[YES], [NO]
PHONE CONNECT
[IPHONE/IPOD], [ANDROID],
[OTHERS]
P.APP AUTO ON
[ON], [OFF]
USB AUTO
[ON], [OFF]
Information on the connections for each device
The available sources differ depending on the setting value.
Please set [PHONE CONNECT] according to the table for the source you want to use.
Description
Select the time notation.
Set to [ON] when using an auxiliary device
connected to the unit.
Set the Bluetooth signal on/off.
Set to [ON] when using the Spotify function.
Clear the Bluetooth device data (device list, PIN
code, call history, phone book, preset phone
numbers) stored in the unit.
[CLEARED] appears when data is successfully
deleted.
Select the type of device and the appropriate
connection method according to your device.
See page 16 for details on the connections for
each device.
• Select [OTHERS] when you connect a mobile
device other than iPhone/Android.
Select [ON] to automatically launch Pioneer ARC
APP when an Android device is connected to the
unit via AOA. (Not available when [MEMORY]/
[IPHONE/IPOD]/[WIRED]/[BLUETOOTH] is selected
in [PHONE CONNECT].)
Select [ON] to automatically switch to [USB]
source when a USB device/iPod is connected to
the unit.
Select [OFF] when a USB device/iPod is being
connected to the unit just for charging.