Download Print this page
Audiovox CMOLF Owner's Manual
Audiovox CMOLF Owner's Manual

Audiovox CMOLF Owner's Manual

License plate rearview camera with selectable normal/reverse image

Advertisement

Quick Links

Model CMOLF
License Plate Rearview Camera
with Selectable Normal/Reverse Image
CMOLF FEATURES:
Built Into License Plate Frame
High Resolution, 1/4" CMOS Color Camera
Compact Zinc Alloy Die Cast Body
Waterproof Housing
Waterproof Microphone
130
Wide Angle View
O
Selectable Normal/Reverse Image
1
128-8104
1 of 8

Advertisement

loading

Summary of Contents for Audiovox CMOLF

  • Page 1 Model CMOLF License Plate Rearview Camera with Selectable Normal/Reverse Image CMOLF FEATURES: • Built Into License Plate Frame • High Resolution, 1/4” CMOS Color Camera • Compact Zinc Alloy Die Cast Body • Waterproof Housing • Waterproof Microphone • Wide Angle View •...
  • Page 2 CONTENTS ITEM LICENSE PLATE WITH CAMERA CAMERA ANGLE ADJUSTMENT WEDGE THEFT-PROOF SCREWS THEFT-PROOF SCREWS FUSE (1A) CAMERA MOUNTING BOLT ANTI-THEFT ALLEN KEY EXTENSION CABLE FIGURE QUANTITY 128-8104 2 of 8...
  • Page 3 Color Camera View: Cable Connector End View: Normal/Reverse Image Jumper: The jumper is located at the camera cable connector. With jumper installed in the harness, the camera image will be normal. When the jumper is removed from the harness, the camera image will be reversed.
  • Page 4: Installation

    Installation. Locate suitable location near the vehicles rear license plate to route the camera cable. The camera cable can be routed through an existing grommet or use a location where a 5/8” hole can be drilled. Be sure to check behind intended drilling location.
  • Page 5 Yellow RCA- connect to Video input Red RCA- connect to audio input (if equipped) Disregard step 5 if connecting to Audiovox 4-pin camera cable. View angle adjustment: This camera frame is designed for universal application. The angle of the image of the installed frame might have to be adjusted depending on the license plate mounting angle.
  • Page 6: Camera Installation

    Camera Installation 1. LICENSE PLATE 2. CAMERA ANGLE ADJUSTMENT WEDGE 3. CAMERA 128-8104 6 of 8...
  • Page 7: Specifications

    Specifications: 1. Power source : DC12V 2. Current: 50mA 3. Signal System: NTSC. 4. Image Device : 1/4” CMOS Sensor. 5. Horizontal Resolution: 420 lines. 6. Video Output:1.0Vp-p Composite (75 ohm load). 7. Minimum Illumination: 0.3LUX 8. Image Display: Normal or Reverse (Selectable). 9.
  • Page 8 © 2006 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128-8104 128-8104 8 of 8...

This manual is also suitable for:

Cmolf - cmolf license plate frame