Remote & Processor Resets - Harman Kardon AVR 2650 Service Manual

AVR 2650
Resetting the Remote
To reset the remote to its factory-default condition, simultaneously press and hold any
Source Selector button and the "0" Number button. When the Program Indicator LED
flashes amber, enter the code "333." When the green LED goes out, the remote control
will be reset.
Processor Reset
If the AVR behaves erratically after a power surge, first turn off the rear-panel Main
Power switch and unplug the AC power cord for at least 3 minutes. Plug the cord back
in and turn the AVR on. If this procedure doesn't help, reset the AVR's processor as
described below.
NOTE: A processor reset erases all user configurations, including video resolution,
speaker and level settings, and tuner presets. After a reset, reenter all of these settings
from your notes in the Appendix worksheets.
To reset the AVR's processor:
1. Press the front-panel Standby/On switch to place the unit in the Standby mode (the
Power Indicator LED will turn amber).
2. Press and hold the front-panel OK button for at least 5 seconds until the
RESET message appears on the front-panel Message display.
NOTE: After performing a processor reset, wait at least 1 minute before pressing any
Source Selector buttons.
If the AVR does not function correctly after a processor reset, contact Harman/kardon at 1-800-
422-8027
25
harman/kardon