Led Light Setting; Speed Control Function; Initializing All Settings - Panasonic EYFPA1C Operating Instructions Manual

Display
b0
b1 Buzzer accompanying green indicator
b Buzzer accompanying red indicator
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the buzzer mode set
to b0 by default.

LED light setting

You can select from two LED light modes.
1. Set the tool to setting configuration mode.
(See page 14.)
. Press the B button once.
The current setting value will be displayed.
3. Press the and
desired value.
Display
d1 Linked to LED light button
d Linked to trigger switch operation
4. Press the OK button to accept the new
setting.
NOTE:
The tool ships with the LED light mode
set to d1 by default.

Speed control function

The speed (RPM) can be changed with the
amount of depression of the trigger.
1. Set the tool to setting configuration mode.
(See page 14.)
. Press the B button three times.
The setting value will be displayed.
3. Press the and
desired value.
Operation
P0
P1
4. Press the OK button to accept the new set-
ting.
Function
No buzzer
buttons to set the
Function
buttons to set the
Function
Speed control ON
Speed control OFF

Initializing all settings

Factory settings
• Torque clutch setting: "F" (torque con-
trol function off)
• Snug point detection level → L1
• Cross thread reduction function → R0
• Rundown error detecting function → 0
• Maintenance interval alarm function
→ 0
• Radio signal range limitation function
→ C0
• Buzzer setting → b0
• LED light setting → d1
• Speed control setting → P0
• This section explains how to revert all tool
settings to their default values at the time of
shipment from the factory.
• The error display will be turned off.
1. Set the tool to the setting configuration
mode.
(See page 14.)
. Press the C button.
The control panel will begin flashing.
Display: The letter "F" flashes on and off.
Battery indication lamp: The upper and
lower bars of the battery flash on and off.
[Fig.19]
3. Press the OK button to accept the select-
ed setting.
The control panel will stop flashing and
light up.
Checking tool settings
• When the tool stops, the current setting
value will be displayed for approximately 
seconds.
• The setting status cannot be checked while
the tool panel is off. Depress the trigger
switch once to turn on the panel.
- 17 -
EN EN