Security Measures - Panasonic CF-35 Operating Instructions Manual

Security Measures

To prevent unauthorized access of your computer the various security measures are provided below.
Situation
You do not want your computer to be used without permission
Same as above, but while you're away temporarily
You want to prevent theft or damage to data by using a floppy disk
You do not want your Supervisor Setup changed without permission
You want to prevent theft of your computer
When you do not want your computer to be used without permission
Set the User Password.
Without the password, access to your computer is impossible.
When the User Password is set
Upon entering your User Pass-
word and pressing
Setting the user password
1
Run the Setup Utility
2
Using and
3
Using and
4
To enable or change your password
Enter your password at the [Enter User Password], then press
CAUTION
Your password will not be displayed on the screen.
Please limit your password to seven characters. Note that there is no
distinction between upper and lower case letters.
White colored keys can be used. Note that space bar and function keys
cannot be used.
Do not input your password while holding down on the
Use only the upper horizontal row of numeric keys to input user pass-
words. The numeric keys combined with alphabet keys on the lower key-
board cannot be used.
Do not forget your password. If a password is forgotten you will be
unable to use your computer.
To disable your password
Using the and
to step 7 .
5
Re-enter your password at the [Enter User Password Again]
(This is for confirmation purposes.)
6
Using and
7
At the confirmation screen, press
Function to use
User Password
Coffee break Password
Prevent operation by using a floppy disk
Remove floppy disk drive
Supervisor Password
Use a security lock
If the correct pass-
.
word is input,
Over three incorrect
attempts,
*
If you are starting from the suspend mode (
attempts the correct password is not input, or if no password is en-
tered for about a minute, the computer returns to the suspend mode.
(enabling, changing, disabling)
( page 36)
, select [System Setup] then press
, select [User Password] then press
keys, select [Delete User Password] then press
, select [Set User Password] then press
Ref erence
below
page 18
page 19
page 22
page 19
page 39
Will Start
Will Not Start*
(Power off)
page 10), if after three
.
or .
. Go
17