Intercom Features Between The Handset And Base Unit - Panasonic JOIP BB-GT1540E Operating Instructions Manual

Intercom Features
example, from different areas of the
house.
1
K i {#}{2}{7}{3}
2
{V}/{^}: Select the desired setting.
3
M i {i}
Note:
L Auto intercom cannot be used when:
– your handset is receiving a
transferred outside call.
– all handsets are being paged by the
base unit.
Answering an intercom call using
auto intercom
1
When you are paged by another
handset, speak into the
microphone.
L To switch to the receiver, press
{s}.
2
To end the intercom, press {i}.
Monitoring audio in a room
You can listen to the sound in a room
where another handset is located.
Important:
L Before using this feature, set auto
intercom on the destination handset to
"On (Ringer Off)" to allow access
by other handsets.
1
Call the destination handset (page
69).
L You can listen to the audio.
2
To mute your sound output, press
1 if necessary.
3
Press {i} to stop monitoring.
70
For product assistance, visit www.globarange.com
For A assistance, visit www.joip.com
Intercom features
between the handset
and base unit
Available model:
BB-GT1520/BB-GT1522/BB-GT1540
Intercom calls
Intercom calls can be made between the
handset and base unit.
Note:
L If you receive an outside call while
talking on the intercom, the interrupt
tone sounds. To answer the call:
– press {TEL} or {IP} on the handset.
– press {TEL} or {IP} on the base
unit. (BB-GT1540)
To turn the interrupt tone off, see page
51.
L When paging unit(s) for an intercom
call, the paged unit(s) beeps for 1
minute.
Making an intercom call
Handset
1
{INT}
2
To page the base unit, press {0}.
L To stop paging, press {i}.
3
When you finish talking, press {i}.
Base unit
BB-GT1520/BB-GT1522
1
{x}
L All handsets beep for 1 minute.
L To stop paging, press {x}.
2
When you finish talking, press {x}.