Am Outdoor Antenna - Panasonic SC-HT440 Operating Instructions Manual

∫ FM frequency step
M
ain unit only
The step is factory-set to 0.2-MHz, but you can change it to receive
broadcasts allocated in 0.1-MHz steps.
1 Press [SELECTOR] to select "FM".
2 Press and hold [SELECTOR].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat steps 1 and 2.
[Note]
After changing the setting, previously preset frequencies will be
cleared. Preset them again.
Using an outdoor antenna (optional)
Use outdoor antennas if radio reception is poor.
≥ Disconnect the antenna when the unit is not in use.
≥ Do not use the outdoor antenna during an electrical storm.
FM outdoor antenna (Using a television antenna)
≥ Disconnect the FM indoor antenna.
≥ The antenna should be installed by a competent technician.
Rework your outdoor antenna's 75 ≠ coaxial cable as follows.
75 ≠ coaxial cable
(not included)
\U.S.A.\and\Canada]
Antenna plug
(not included)
1 Remove a piece of the outer
vinyl insulator.
z)
13
10 mm ( /
32
z)
13
10 mm ( /
32
Peel back
z)
9
7 mm ( /
32
LOOP
2 Carefully pull the tabs
apart to remove the cover.
2
1
1
The illustration shows the model for U.S.A. and Canada.
Leave the AM loop antenna connected.
LOOP
ANT GND
FM ANT
75
AM
ANT
EXT
3 Install the coaxial cable.
Clamp the cable conductor, and
wind it on so that it does not
contact anything else.
Clamp with pliers

AM outdoor antenna

(Using a vinyl wire)
Run a piece of vinyl wire
horizontally across a window or
other convenient location.
5 to 12 m
(16 to 39 feet)
4 Attach the cover.
25