Pci Mezzanine Card (Pmc) Interface - Motorola MVME2301 Installation And Use Manual

08003E2xxxxx is stored in NVRAM. The MVME230x debugger,
PPCBug, has the capability to retrieve the Ethernet station address
via the CNFG command.
Note
If the data in NVRAM is lost, use the number on the label in the
PMC connector keepout area to restore it.
For the pin assignments of the 10Base-T/100Base-TX connector,
refer to Appendix C.
At the physical layer, the Ethernet interface bandwidth is
10Mbit/second for 10Base T. For the 100Base TX, it is
100Mbit/second. Refer to the BBRAM/TOD Clock memory map
description in the MVME2300-Series VME Processor Module
Programmer's Reference Guide for detailed programming
information.

PCI Mezzanine Card (PMC) Interface

A key feature of the MVME230x family is the PCI bus. In addition
to the on-board local bus devices (Ethernet, etc.), the PCI bus
supports an industry-standard mezzanine interface, IEEE P1386.1
PCI Mezzanine Card (PMC).
PMC modules offer a variety of possibilities for I/O expansion such
as FDDI (Fiber Distributed Data Interface), ATM (Asynchronous
Transfer Mode), graphics, Ethernet, or SCSI ports. For a complete
listing of available PMCs, go to the GroupIPC WorldWideWeb site
at URL
PMC front panel and rear P2 I/O. There is also provision for
stacking one or two PMC carrier boards, or PMCspan PCI
expansion modules, on the MVME230x for additional expansion.
The unique Ethernet address is set at the factory and
should not be changed. Any attempt to change this
address may create node or bus contention and thereby
render the board inoperable.
http://www.groupipc.com
Functional Description
/ . The MVME230x supports
3
3-13