Led Indicators; Additional Information; Warranty Information; Dip Switches - D-Link dgs-1024d Quick Installation Manual

Hide thumbs Also See for dgs-1024d:
Table of Contents

Advertisement

Available languages

Available languages

LED Indicators

The LED indicators allow you to monitor, diagnose,
and troubleshoot potential problems with the switch,
connection, or attached devices.
LED
Color
State
Light on
Power
Green
Light off
On
Green
Blinking
Link/Act/
Speed
On
Amber
Blinking
Cable Diagnostics (During Boot Only)
Port Link/Act/
Speed LED Color
No Faults Detected /Good Cable
Green
Amber
Open or Short Circuit

DIP Switches

The DIP switches on the front panel allow easy
configuration of the advanced features of the DGS-
Indication
1016D and DGS-1024D.
Power on
Switch
Power off
Connection (or link) at
1000 Mbps
Flow
Control
Reception or
Transmission at 1000
Mbps
Isolation
Connection (or link) at
10/100 Mbps
Storm
Control
Reception or
Transmission at 10/100
Port Isolation:
Mbps
DGS-1016D - When enabled, ports 1 to 15 will
be isolated from each other, but will still be able to
communicate with port 16. Port 16 will be able to
communicate with all the ports available on this switch.
Status
DGS-1024D - When enabled, ports 1 to 23 will
be isolated from each other, but will still be able to
Connection
communicate with port 24. Port 24 will be able to
communicate with all the ports available on this switch.
Note: The switch must be power cycled
after changing DIP Switch settings for new
settings to take effect

Additional Information

Additional help and product information is available
online at http://www.dlink.com.

Warranty Information

Please visit http://warranty.dlink.com/ for warranty
information for your region.
©2015 D-Link Corporation. All rights reserved.
Trademarks or registered trademarks are the property
of their respective holders. Software and specifications
subject to change without notice.
DIP
Function Controlled
Enables/Disable IEEE 802.az
EEE
Energy-Efficient Ethernet Feature
Enables/Disable Flow Control
Feature
Port Isolation: See Below
Port
Storm Control: When enabled, a
broadcast storm control threshold
and
value of 128 kbps will be applied
to incoming broadcast packets on
all ports.
.
Default
Off
On
Off
3 3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs-1016dDgs-1024d

Table of Contents