Audiovox Prestige Platinum SS9000 Owner's Manual page 14

TRANSCEIVER ICONS AND THEIR INDICATIONS
When Disarmed, Press the Arm/Lock button to Lock and Arm
the System. The Lock Icon is displayed on the LCD panel & the
parking lights flash once.
When Armed, Press the Disarm/Unlock button to
Unlock and Disarm the System. The Unlock Icon is displayed
on the LCD panel & the parking lights flash twice.
When the Key Icon Button Has Been Operated for 3 seconds
the trunk open icon will flash on the LED Screen. If text mode
was selected, the words Trunk Open will appear and remain
on the screen until the trunk is shut.
When the Key Icon Button is pressed 2 times in succession
The three puffs of smoke are displayed on the LCD screen
while the vehicle is running. The exhaust indication will flash
and the hour glass will indicate count down timer based on the
5, 10, 15, or 20 minute run time set up by your installation cen-
ter. When the unit shuts off the exhaust indication will turn off
and the transmitter will play a melody.
NOTE: Engine can be started in many modes armed, disarmed,
valet, etc... The screen shown is Locked/Armed and running.
When the Panic Mode has been activated and the
system is armed the vehicle's lights will flash, the
siren and lock icon will be displayed on the LCD
screen and the siren will beep. If the system is
disarmed and the Panic Mode is activated, the
lights will flash unlock icon will be displayed and
the siren will beep on the LCD screen.
When ever the vehicle is operated from the two way transmitter, the
unit will beep responsive to the function executed at the vehicle. 1
beep when armed, 2 beeps when disarmed, etc... at times It may
be inconvenient or too noisy to hear the beep tones, so the system
allows you to set the unit for vibrate mode. To toggle on or off beep
tones/vibrate, Simultaneously press the "F" and unlock buttons.
The icons shown left will appear in the upper left hand corner of the
screen to indicate vibrate.If the alarm system has been triggered,
the icon displayed on the transmitter LCD will indicate which zone
has been activated, as well sound the beep tones, or vibrate
dependent upon the setting as shown above. The following trigger
patterns will be displayed.
Triggered and the entry attempt was made to one of the
vehicle Doors.
Triggered and entry attempt was made to the vehicles Hood
Page 14
128-8842
14 of 20